You searched for Compass Command
1. compass command
Syntax: compass point <point of interest>
compass lead <point of interest>
compass add <name>
compass name <vnum> <new name>
compass description <vnum> <new description>
compass remove <vnum>
compass list (<'custom'>)
The compass command is useful to locate points of interest in an area.
By pointing your compass at a certain room of interest, it will supply you
with the run path, such as 'run 3sen'. To begin the journey to a point of
interest, you can use the run path of simply 'compass lead <name>' and you
begin running to your destination. Name refers to any word in the name or
description of the compass point.
To see if there are any pre‑made points of interest in the area you are
currently in, use 'compass list'. This will show any locations that the
builders of that area have added as well as any locations you have custom
added to the area's compass.
Using 'compass list custom' will display a complete list of locations you
have custom added. You can add a maximum of 10 locations and each must be
given a name with the 'custom name' command in order for your compass to
point in the right direction or lead you to the location.
You can give your custom points of interest a more specific description
with the 'compass description' command.
Related helpfiles: Cartography, Runto.